Summary: This mount was easy to install and sturdy, and I'd gladly buy it again. It allows side-to-side adjustment of about 6" for my 64" plasma (more adjustment for smaller screens), but no tilt adjustment - the TV ends up TV is parallel to the wall (good for my installation). It's pretty easy to hang the TV on the mount.
Summary: Very well made and 100% confidence that its the right model for my TV. Attaches easily to wall, highly adaptable to stud locations, high quality steel parts. Very clear directions--if you've never installed a wall mount before, its very easy to follow and make sure you're on the right track. Holds TV very securely (I have a 95lb Samsung plasma). Would highly recommend this brand and this mount. Peerless' website has a mount finder program...so simple.
Summary: Before i purchase the Peerless SF670, i tried 4 other wall mounts for my 60" Pioneer Elite Plasma TV and non of them were big enough or strong enough to hold my 200 lbs TV. I am completely satisfy with this product.
Summary: If you are looking to mount a large TV or even a small vehicle to your wall, this mount will do the trick. I purchased it mainly because it was large enough to span three studs and needed it to be that wide because of where I needed it mounted. I didn't really need three studs for a 45lb. TV but rest assured this will hold just about any flat TV you could ever buy. Installation was simple and I didn't even read the directions.
Summary: This is my first time mounting a TV. The directions weren't all that clear to 2 engineers, albeit we're software guys. The worst part was that the ton of bolts and washers that came with the mount did NOT work with the KRP-M600. Had to run to Home-Depot to buy some bolts and washers. Once the TV is mounted though, it's solid as a rock.
Summary: This mount is super easy to install if you are the least bit knowledgeable about using a pencil, a drill and a level. The mount fits nice and close to the wall and the whole unit is nice and rugged. I was not worried about hanging my brand new 52" Sony. The price as of this writing is just under $90. You will never do better at a big box store. They are at LEAST 3 times that there, usually 4-5 times.
Summary: This is a very strong flat mount (no tilt) that spans three studs on 16" centers. I bought two of these. Shorter mounts can span only two studs and may make it difficult to center the flat panel display properly. In my case, I had studs almost in the center of both walls where I wanted displays. A two-stud mount would have forced the displays to be well off-center. I believe the 250 lb rating. Three studs, six carriage bolts: those plasma displays are not going anywhere.
Summary: This tv mount is worth the extra $30 people. Why? It attaches to 3 studs instead of two. This mounting method is far more secure and gives me a lot of piece of mind. Don't spend $2,000+ on a tv and $60 on a cheap mount. Installation is very simple.
Summary: I purchashed this mount after tons of research. You see, I had trouble finding a mount to fit my TV because my TV has the screws placed too far apart. I have the Pioneer PDP-6020FD. This was one of the only afordable low profile mounts in the market that would fit my TV without having to buy special adapters (which cost an additional $35).