Excerpt: This is a great option for cooling memory or other chipsets in an open air tech station or other situation where there isn't direct airflow. The plastic feels a little flimsy but it gets the job done. It mounts using a single screw anywhere you have one so it can mount to a case or motherboard. It has 3 speeds and is quiet enough to not be noticeable.
Summary: The Good: I did not get this here but let me tell you all somthing I have it pointed at my vid card and the temp went from 145 to 110 it really put out the air and the 3 speeds help a lot oh and the blue lites are cool also
Antec Spot Cool: Cool Your Computer - Spot Fan Review
23 March 2008
Summary: Introduction ########## A friend of mine had this to cool his memory, but then later decided to purchase some better memory. He gave me this to see if I could make some use of it. I didn't really require and additional motherboard cooling but thought id still give this a try. So here is my review. The Fan ####### It's a really nice 10cm fan which is designed to be mounted wherever you want additional cooling.
Summary: Bought it, installed it, temps dropped +10C...
Feels well made, glows lovely and blue, has a switch to run at full speed or let the fan decide with the built in temp sensors.
Running two GTX 570 in SLI and it used to sound like a plane taking off when running high end games, installed this fan at the end of the cards to push hot air out the back of the case and it works a treat, see picture;
Summary: I have 2 of these in my case one for the northbridge and 1 for my xfire cards. They dropped the north bridge temps by 25c and the gfx cards by 15c. I have a asus x48 rampage and 2 3870's. sitting close. For those with a multiple gfx cards they are a god send evened out temps for 1st n 2nd cards.
Excerpt: This is a great product that actually does what it claims. There's a ton of hyperbole in the air-cooling world, so I was a little skeptical at first, but this product does what it says. Any motherboard screw mount is a mount for this fan. A must for the watercooled system, since many VREGs and chipsets depend on the air thrown off by the CPU fan to help cool them. That airflow vanishes when you install a waterblock. A product such as this can replace that lost airflow.
Pros: Pointed it at my chipset and it dropped the temps by 9-10 degrees centigrade. Super easy installation. Articulates well so you can point it where you want to. 3-speed fan.
Excerpt: Покупал для охлаждения моста, но так и не смог установить. В лежачем положении всё нормально, как устанавливаю комп вертикально, ножка разгибается! Идея - отличная, но вот её реализация - мягко говоря не очень!
Pros: Поворотная конструкция, легкость монтажа.
Cons: Слабая ножка, гнется под собственным весом. Установка возможна либо на открытый стенд, либо свисанием сверху в низ. Хлипкий пластик корпуса скрепленный в двух точках супер клеем.
Excerpt: Refroidi efficacement mes deux Ati4850, en idle je suis entre 38° et 42° et en burn je dépasse pas les 65° faut dire aussi que j'ai installé sur chaque carte un Zalman VF1000-LED mais le chipset de ma Gigabyte GA-X48-DS5 chauffe beaucoup entre 65° et 70° c'est pour cela que j'ai commandé un deuxième ˆ.ˆ Perso il est à la 2ème vitesse, bruit acceptable, on peu l'orienter comme on veut, les leds bleus tombent très bien, bref achetez si vous aimez les perf L'Overclok et le...