Summary: This device appeared to be quite easy to set up; however, after the initial setup with WPS, which went quite well, I was surprised to find the following day that it was not connected any longer. Went through the WPS setup again, very easy, quickly connected. Same story, 24 hours later it disconnects. After this happened for the third consecutive day, I plugged the bridge into the PC and figured I was going to have to manually configure it.
Summary: My unit loses it's WiFi connection after a few hours and has to be reset and re-powered to get a connection back. The unit is difficult to configure without Windows, the install disk only works from Windows. If you're not IP-savvy, this unit may not be for you. I've tried to upgrade the firmware, but the unit's web interface will not allow uploads from Firefox, it complains "Chrome not supported". FYI - the unit's default IP address is 192.168.10.110.
Forgetful Adapter - Where is the configuration - Network Confusion
P. M. Lewis "Im-Not-Ted", Amazon
17 September 2010
Summary: In the first week I reset the adapter configuration three times. Finally I gave the device a assigned IP address (using manual configuration) which seemed to work. Then I noticed the other wireless devices on the network dropping signal, losing DHCP, etc. Each time I would troubleshoot to find that this adapter had reset itself to a 192.x address instead of the private address I assigned it. Something is off, weird, confused with this device.