www.testfreaks.com

Reviews, reviews, reviews...

Genelec S30C

Genelec S30C

Genelec S30C Tri-amplified Monitoring System frequency response: Read more

Best Price at Amazon

Specifications

Feature
Value
Comment
Lower cut-off frequency, -3 dB:
< 42 Hz
Upper cut-off frequency, -3 dB:
> 25 kHz
Free field frequency response of system:
43 Hz - 25 kHz (± 2.5 dB)
Maximum short term sine wave acoustic output on axis in half space, averaged from 100 Hz to 3 kHz: @1m @0.5 m
> 111 dB SPL > 117 dB SPL
Maximum long term RMS acoustic output in same conditions with IEC-weighted noise (limited by driver unit protection circuit): @1m @0.5 m
> 102 dB SPL > 108 dB SPL
Maximum peak acoustic output per pair on top of console, @ 1m from the engineer with music material:
> 122 dB
Self generated noise level in free field @ 1m on axis:
< 10 dB (A-weighted)
Harmonic distortion at 90 dB SPL at 1m on axis: freq.  < 200 Hz freq.  > 200 Hz
< 2% < 1%
Drivers: Bass Midrange Treble
210 mm cone 80 mm cone 9x65 mm ribbon
Weight:
20 kg (44 lb)
Dimensions: Height Width Depth
495 mm (19 1/2") 320 mm (12 5/8") 290 mm (11 1/3")
Bass amplifier output power with an 8 Ohm load:
Short term 120W
Midrange amplifier output power with an 8 Ohm load:
Short term 120W
Treble amplifier output power with an 8 Ohm load:
Short term 120W
Slew rate:
80V/micros
Amplifier system distortion at nominal output:
THD < 0.05% SMPTE-IM < 0.05 % CCIF-IM < 0.05 % DIM 100 < 0.05 %
Signal to Noise ratio, referred to full output:
Bass > 100 dB Midrange > 100 dB Treble > 100 dB
Mains voltage:
100/200V or 115/230V
Voltage operating range at 230V setting:
207 - 253V (±10%)
Power consumption:
Idle 30W Full output 200W
Input connector: XLR female
pin1 gnd pin2 + pin3 -
Input impedance:
10 kOhm
Input level for 100 dB SPL output @1m:
variable from +6 to -6 dBu
Input level for maximum short term output of 111 dB SPL @1m:
variable from +17 to +5 dBu
Subsonic filter below 38 Hz:
18 dB/octave
Ultrasonic filter above 25 kHz:
12 db/octave
Crossover frequency:
bass/mid 420 Hz mid/treble 4 kHz
Crossover acoustical slopes:
18 - 24 dB/octave
Crossover level control operating range in 1 dB steps:
bass from 0 to -6 dB mid from 0 to -6 dB treble from 0 to -6 dB
Bass roll-off control in 2 dB steps:
from 0 to -8 dB @42 Hz
Bass tilt control in 2 dB steps:
from 0 to -8 dB @80 Hz
Release Date
First seen
9 May 2008