Pros: Good features; if someone wants 8 or 10 drives in a small case, this can be an excellent choice. The motherboard tray is 'cut off and rolled' near the front edge of the motherboard so there's minimal flex. This design also allows much easier access to see and install cables into the stacked SATA ...
Cons: Despite my high preference for this case, there could be design improvements, however, and some Build Process Adjustments help, too. The case's 8" width is still a half-inch too narrow on two counts: this doesn't allow HDDs to be mounted either Nose Out or Tail Out - they can only be inserted Nos...
Summary: I ordered this case for a budget build and it fit the bill perfectly. Plenty of room and fan placement options. I like the bottom PSU mounting as well. The only thing that could be better is the wire routing.
Summary: This case, which I bought for $35 after rebate, is amazing. Has everything I could want and more. That being said, it is a budget case. That means it's kinda flimsy and just generally not super well made.
Cons: -hard rubber feet(doesn't prevent vibration or scratching) -Lack of PSU cable hole, will get messy -Air filter is weird, holds on with magnets, for me and my OCD, I will constantly be making sure it is on squarely.
Excerpt: Overall, I'm very happy with the case, plenty of cooling, USB 3.0, relatively understated (when compared to a lot of cases). However, the quality is not fantastic, the toolless fittings feel a little flimsy, and the I/O shield-motherboard fit is dreadful, the I/O sits maybe 1 cm away from being...
Excerpt: I've used this case to replace an aging Akasa Eclipse case. Although it's not in the same league, this is a good basic case that doesn't look cheap and has some handy features. I would recommend this case to anyone looking to build a decent PC.
Summary: I get to build in a lot of cheap cases for work and this particular case was easy on the eye and not poorly built. By removing the 5.25" bays you could easily get a water-cooling system in here with room to spare, but just because you can doesn't mean I'd recommend it.
Excerpt: Пришлось смастерить переходник usb 3.0 to usb 2.0 из картридера под слот 3.5", имейте ввиду, что ножки тонкие нужны. Сзади кабели от жестких дисков расположены вплотную к боковой стенке. Вентилятор пришлось запитать от 7В(12-5).
Pros: Строгий внешний вид, боковые крышки без всяких перфораций и окошек.Нижнее расположение БП, горячий воздух кулера ЦП не проходит через него. Много мест для вентиляторов. Резет случайно не нажмешь. USB порты расположены сверху.
Cons: Нет переходника с usb 3.0 на usb 2.0. Нельзя подключить передние порты к материнке с usb 2.0. Фильтр сверху кривой, крепится на магнитах, но касаются корпуса только угловые. Вентилятор шумноват. Безвинтовые крепления ЖД не очень, в нижних посадочных местах заметный люфт.