Summary: I hope the power supply doesn't go out, I'll probably have to trash the whole box as I doubt there's a replacement available. I would not purchase again.
Pros: quiet nice looking
Cons: Overpriced. Case fan cable and power LED cable are too short to reach on my motherboard (GA-Z77N-WIFI). You'd expect better from a premium price product. IMO, the design is not very well thought out.
Summary: My system worked for 1 week, then quit because the PSU is not powerful enough Fans quit working, then whole system quit working. also, cases with 120mm fans are quieter, but this one isn't terribly loud. Took the video card out, (which was only supposed to pull 35W) and the fans started again. Tried a more powerful power supply, and system worked fine.
Summary: I like this case very much but unfortunately the PSU seems to be weak, my old Dell 120W PSU produces much better voltages than this 150W rating. The PSU produces slightly lower voltages almost across the 24-pins, especially the standby pin-9 VSB only comes up to 4.80v, which causes the motherboard not functioning properly for the PS_ON signal. Maybe I got a bad unit or something.
Summary: If you suspect you'll have cable length issues, check out item N82E16812186072 (SYBA cable SY-CAB65008). This should give you just enough length to overcome the design flaw.
Pros: Small. 150w PSU was just right for the configuration I came up with. Case looks nice sitting in an entertainment center along side other A/V equipment.
Cons: Not terribly high quality. Case bends and flexes easily. The big deal breaker - the cable lengths are terrible. It seems like they just came up with random lengths of cable and started slapping things together. Looking at your motherboard from behind the real I/O panel, if you have a PSU connector on the left, the back right, or near the back side this cable WILL NOT reach. It's about 1-2'' short of being a comfortable fit in these positions. The only place it will be...
Summary: I should perhaps be kinder to Antec. Mini ITX cases are problematic, and case design lags far behind mini ITX in general. But this is just not thought through. The power in to the PSU is simply ridiculous. The front panel wires are 1/2 to an inch too short to allow any sort of elegant routing. You stretch em and hope they hold. They dont always work either. They are stressed. Sorry Antec. Nice try, but you missed.
Pros: on the outside doesn't mean quality on the inside. Pros: It's small
Cons: Poor quality and design - particularrly the PSU. I have to have my wires "just so" or no go. One look and you realize this was designed by Bozo the Clown. The power in cable has to do some crazy limbo, with sharp bends - a fail point a 4 year old could see. The same fate awaits the USB front panel cable. I haven't yet tried the front e-SATA, but based on the rest of the wreck, my optimism is low.